Comfort

Thermalinc.com Home : Comfort Heating : Garage / Shop Heaters

Garage / Shop Heaters        Starting @ $301.45 US         In stock

A Heater Designed for Your Garage or Shop!
Perfect for a TWO Car Garage with 12' Ceilings.

Aitken 524-T Electric Unit Heater
Great Price for a Great Heater!
We Stock this Unit for 24 Hr shiping!
    Unique Design Allows
    Quick Easy Electric hook up!

    • Universial Heater: Eight wattages, two voltage for field hook up to meet your wattage requirements and existing voltage.
    • Built-in Thermostat. Ready to run without running external wire. Self contained!
    • Complete with Mounting bracket! Mounts directly to ceiling or wall.

    5000 Watt IN STOCK
    for Same day shippment!!


  • Use the 5000 watt for garages up to 3500 cubic Feet!*

  • Use the 7500 watt for garages up to 5000 cubic Feet!*
AUH 524-T Electric Unit Heater Specifications
Bulletin Instruction Sheet 5000 watt Instruction Sheet 7500 watt
MODEL NUMBER VOLTS WATTS BTU/hr. PHASE AIR VOLUME CFM THROW HEATER AMPS BREAKER SIZE SHIP WT. lbs PRICE ADD TO CART
AUH-524TA 240 5,000 17,065 1 350 18' 20.9 30 Amp 25 $317.74
AUH-724ST 240 7,500 25,598 1 400 18' 31.25 40 Amp 30 $523.09
**This heater is field convertable for different Wattages and Voltages (see Instruction Manual)
* Area Coverage is dependent on insulation and location of your Garage.
   Please use our Heat Calculator for more percise sizing!

  • Easy to Install and Service By removing one screw, the bottom control box swings down on hinges for complete access to controls and wiring to permit full access for installation, and for cleaning and servicing without dismounting the shop heater. Isolated terminals allow for Cool 75° C hook-up wire.
  • Housing Heavy gauge steel with desert tan baked enamel finish. Side panel removeable to gain full access to element and Garage Heater fan area.
  • Adjustable louvers provide desireable easy air flow adjustments.
  • Branch Circuit Fusing as standard on All heaters over 48 Amps. Wiring diagram attached to the inside of the control box cover.
  • Heater Fan Motor Totally enclosued, impedance protected, unit bearing design with high starting and running torques. Heater Fan motor and controls operate directly off of the line voltage of 208 and 240 volt heaters. (on 277 and 480 volt heaters a transformer is built into the unit to provide proper fan motor and control operation.)
  • Heating Elements Non-glowing design using a bank of tubular captured by Steel plate fins provide uniform heat and extremely long life.
  • Thermal Cutout is built into the system to automatically shut of heater in event of overheating due to any cause.


    Installation Instruction Sheet
    Bulletin

  • We've seen your application. Call Us for application Assistance

    (901) 452-4516